Banner
Navigation
loco-info.com
The reference for locomotives and railcars

Sligo, Leitrim & Northern Counties Lough class

Ulster Transport Authority class Z

Northern Ireland 1949 2 produced
“Lough Erne” stored at Whitehead R. Joanes / Railway Preservation Society of Ireland

After the five Leitrim class locomotives from the 19th century, SL&NCR had procured three more Sir Henry class locomotives in 1904, 1905 and 1917, which also had the 0-6-4T wheel arrangement and were manufactured by Beyer, Peacock & Co. After the Second World War, the existing fleet of vehicles was no longer sufficient and in poor condition, so that the procurement of a powerful Garratt locomotive was initially considered.

The line was now situated between Ireland and Northern Ireland, which made operation not exactly easy. In addition, it was in a sparsely populated and not very prosperous area, which significantly worsened the financial situation and made it impossible to buy an expensive locomotive. Finally, two smaller locomotives were ordered, which again had the 0-6-4T wheel arrangement and were completed in 1949. So they were the last steam locomotives built for an Irish broad gauge railway. They were named after the lakes Lough Melvin and Lough Erne, which explains the name of the class.

Since the SL&NCR could not pay for the locomotives, lengthy negotiations with the government of Northern Ireland followed. It was finally agreed on a lease purchase and the locomotives were used until the line was closed in 1957. They were then sold to the Ulster Transport Authority and used by them in shunting service as class Z until 1967 and 1972, respectively. Preserved by the Railway Preservation Society of Ireland, Lough Erne is now at Whitehead on the Northern Irish coast.

Technical data

General

Built
1949
Manufacturers
Beyer, Peacock & Co.
Wheel arrangement
0-6-4T
Gauge
1,600 mm (Irish broad gauge)

Dimensions and weights

Wheelbase
7.09 m
Service mass
53.3 t
Adhesion mass
37.6 t
Rigid wheelbase
3.37 m
Water capacity
5,909 l
Fuel capacity
2 t (coal)

Boiler

Grate area
1.672 m²
Firebox surface
9.151 m²
Tube heating surface
97.548 m²
Evaporative heating surface
106.699 m²
Total heating surface
106.7 m²

Power plant

Driver diameter
1,422 mm
Boiler pressure
11 bar
Expansion type
simple expansion
Cylinders
two, 457 x 610 mm

Power

Power source
steam
Estimated power
373 kW (507 PS)
Starting effort
84.0 kN

Calculated values

Factor of adhesion
1 : 4.39
Optimal speed
27 km/h
Power-to-weight ratio
7.0 kW/t
Heating Surface Equivalent
152.5 m²
Cylinder volume/HSE
1 : 1,312.92
Adhesive weight/Total
1 : 1.42
Tractive force/Heating surface
1 : 16.44
Grate area/Heating surface
1 : 63.82
Firebox/Tube surface
1 : 10.66
Auf Deutsch umschalten

Settings

Your settings are retained for this browser session only.

Consent to cookies

We use cookies to save your display settings. If you decline, the settings are retained only for the current browser session.