Banner
Navigation
loco-info.com
The reference for locomotives and railcars

Belgian Railway Franco locomotive

Belgium 1932 1 produced
Revue générale des chemins de fer, November 1935

In 1932, the Belgian firm of Ateliers Métallurgiques in Tubize built the world's only Quadruplex locomotive with the assistance of the Italian Attilo Franco. Its special design was not only to increase power, but also to increase efficiency. It was much larger than anything the Belgian Railways needed, but was used as a prototype for a planned compound hexaplex locomotive for the Soviet Railways that was even larger, but never realized.

The locomotive consisted of three sections called A, B and C. The middle B section housed a special double boiler that had two central fireboxes. These were located side by side, were each fired by one fireman and had their own coal bunker. Each end of this section had a cab since the locomotive was way too long to use turntables.

The A and C sections contained large Franco feedwater heaters which were encased by the water tanks. The chimneys were on the extreme ends of these sections since the hot gases only escaped to the atmosphere after passing through the feedwater heater. A part of the hot gases was ducted to the grates to mix with the cold air.

A total of ten driving axles were powered by four pairs of two cylinders each. The B section had two pairs of two driving axles, with carrying axles at the ends and one in the middle. The A and C sections had three driving axles and one trailing axle. This led to the wheel arrangement 0-6-2+2-4-2-4-2+2-6-0T. With this arrangement, the locomotive could pull 1,200 tonnes on an incline of 1.6 percent. Additionally, it was found to have a low specific consumption.

After the trials, the locomotive with the builder's number 2096 was shown on the Brussels exhibition in 1935 and then withdrawn. In 1943, it was split in half and rebuilt to two 0-6-2+2-6-2T locomotives by adding an additional driving axle below the half of the old B section. After getting to Germany in 1944, they were used in a shipyard. When the war ended, the Soviets brought them to two different locations in Poland where they were used for a few years.

Locomotive Magazine, August 1933

Technical data

General

Built
1932
Manufacturers
Tubize
Wheel arrangement
0-6-2+2-4-2-4-2+2-6-0T
Gauge
1,435 mm (Standard gauge)

Dimensions and weights

Length
29.00 m
Service mass
230 t
Adhesion mass
164 t
Axle load
16.3 t
Water capacity
35,600 l
Fuel capacity
9 t (coal)

Boiler

Grate area
6.5 m²
Tube heating surface
251.4 m²
Superheater surface
77.2 m²

Power plant

Driver diameter
1,370 mm
Boiler pressure
14 bar
Expansion type
simple expansion
Cylinders
eight, 435 x 650 mm

Power

Power source
steam
Indicated power
2,206 kW (2,999 PS)
Starting effort
427.3 kN

Calculated values

Factor of adhesion
1 : 3.76
Optimal speed
32 km/h
Power-to-weight ratio
9.6 kW/t
Adhesive weight/Total
1 : 1.40
Auf Deutsch umschalten

Settings

Your settings are retained for this browser session only.

Consent to cookies

We use cookies to save your display settings. If you decline, the settings are retained only for the current browser session.