loco-info.com
The reference for locomotives and railcars
Navigation
Random
Search
Compare
Settings
Bern-Lötschberg-Simplon Railway Fb 5/7
later Be 5/7
Switzerland | 1913
13 produced
Works photo of the SLM
Works photo of the SLM
SBB Historic

After the tests with the two electric locomotives on the Spiez-Frutigen route, conclusions were drawn from the experience as to what a new, series-built locomotive should look like. The F 2x3/3 impressed with its power train, while the Fb 2x2/3 with its carrying axles improved running smoothness and the ability to negotiate curves. That is why the decision was made to order a similar power train from the manufacturers of the F 2x3/3 locomotives, but instead of bogies they were equipped with coupled axles fixed in the frame and a carrying axle at each end. Additional electrical assemblies were supplied by BBC to shorten delivery times. A total of 13 locomotives were delivered in 1913, which were to pull both freight and passenger trains on the newly built mountain route, including the 14.6 km long Lötschberg tunnel.

In order to achieve good running characteristics, three of the five driven axles could be moved sideways. While the middle one could be moved by 25 mm, the first and fifth were each mounted with the adjacent carrying axle in a Krauss-Helmholtz bogie. With the lateral deflection of the carrying axles by a maximum of 78 mm, they were moved by up to 40 mm. Despite the five driven axles, this made a fixed wheelbase of just 4,500 mm possible.

Between the second and third, as well as between the third and fourth coupled axles, there was a 14-tonne series motor on the frame, which drove a jackshaft via a Citroën gearbox underneath. By means of a rod triangle on each side, both engines acted on the middle axle. Since the rod triangles often broke under the high load during operation, they were later replaced with cast pieces. In order to achieve a large number of speed steps with a relatively small number of taps on the transformers, the next of the twelve steps of only one of the motors was switched alternately to obtain a total of 24 steps.

Schematic drawing
Schematic drawing
Die Lokomotive, June 1914

With an hourly output of 2,500 hp, the Fb 5/7, which was soon renamed the Be 5/7, was the most powerful electric locomotive in the world. On the ramp with a gradient of 2.7 percent, it was able to pull trains weighing 330 tonnes at 50 km/h. After the predecessor locomotive had been moved to flatter routes, the Be 5/7 was the only locomotive used on this route. Thanks to the good running characteristics, the locomotives were later approved for 80 instead of 75 km/h, one locomotive was even equipped with four smaller motors and could run 90 km/h. From the second half of the 1940s, they were increasingly pushed into freight train service b the Ae 4/4 and when the Re 4/4 were delivered in 1964, they were quickly scrapped.

General
Built1913
Manufacturermechanical part: SLM, electrical part: Oerlikon, BBC
Axle config1-E-1 
Gauge4 ft 8 1/2 in (Standard gauge)
Dimensions and Weights
Length52 ft 5 15/16 in
Wheelbase37 ft 2 7/16 in
Rigid wheelbase14 ft 9 3/16 in
Service weight235,894 lbs
Adhesive weight172,401 lbs
Axle load36,597 lbs
Boiler
Power Plant
Power
Power sourceelectric - AC
Electric system15.000 V 16⅔ Hz
Continuous power2,467 hp (1,840 kW)
Top speed50 mph
Starting effort39,679 lbf
Calculated Values
electric locomotive
freight
passenger
last changed: 04/2022
loading...

We use cookies to save the following settings:

  • selected navigation structure
  • selected language
  • preferred units
  • spelling of railway company names

If you refuse the use of cookies, the settings will only be retained for the current session and will be reset to the default values the next time you visit the site.

Display of units

Here you can set the desired unit system for the technical data.

  • Metric: Lengths in meters, weights in tonnes, and volumes in cubic meters
  • Imperial (UK): Lengths in feet/inches, weights in long tons and volumes in imperial gallons
  • Imperial (US): Lengths in feet/inches, weights in pounds, and volumes in US gallons
  • Individual: Depends on the country of origin of each locomotive
Operator names

Here you can set the display of railway company names.

  • Short: Abbreviation or short form of the name
  • Standard: commonly used name, partially translated to English
  • Complete: full name in local language