loco-info.com
The reference for locomotives and railcars
Navigation
Random
Search
Compare
Settings
Prussian T 16
German Reichsbahn class 942-4
Germany | 1905
343 produced
Die Lokomotive, October 1915

Since the T 15 could not convince with its two-piece chassis, the T 16 was developed with a one-piece, ten-coupled chassis. In order to still achieve good cornering ability, the Gölsdorf axle principle, first used in 1897, was used. In contrast to more complicated, radially adjustable constructions, all axles of the T 16 were fixed in the frame, but the first, third and fifth could be moved sideways. This made it possible for the two outermost axles to move to the inside of the curve and the middle one to the outside in curves. Despite the simple design, this led to a reduction in wear and noise in tight curves.

Sectional drawing with meaasurements
Sectional drawing with meaasurements
Die Lokomotive, October 1915

Thanks to the use of superheated steam technology, the new locomotive was more powerful and more economical than its predecessors, and because the entire weight was on the coupled axles, it was also able to transmit its power well to the tracks. They were often used on steep stretches in the low mountain ranges and on the slopes of large river valleys in Prussia, but they were also used on the level to pull heavier freight trains. With a maximum speed of 40 km/h, it was too slow for main routes even with freight trains.

94 249 as the only surviving locomotive in October 2006
94 249 as the only surviving locomotive in October 2006
Heiligenstädter Eisenbahnverein e.V.

The Prussian State Railways ordered 343 engines, which Schwartzkopff delivered between 1905 and 1913. In the course of production there were minor changes to the boiler dimensions and weights. The initially installed smoke box superheater was supplemented by a smoke tube superheater from 1907. In addition, the batch from 1909 had the third instead of the fourth axle powered, with the third axle no longer being able to be shifted sideways. The imperial railways in Alsace-Lorraine had twelve units built according to the same design plans by Grafenstaden near Strasbourg.

After the end of the First World War, 65 examples remained abroad, the rest were taken over by the Reichsbahn and later given the numbers 94 201 to 94 467. Between these, however, there were also some T 161 which had been wrongly numbered. During the Second World War, 32 pieces from Poland and one from Belgium came back into the stock, which received the numbers 94 468 to 94 490. After the war, most of them went to the Bundesbahn, where they were decommissioned in 1955. The Reichsbahn of the GDR used their last examples until 1968, one of which still exists today and is on static display in Heilbad Heiligenstadt. 39 pieces remained in Poland, where they were used as Tkw1.

Variant1905 variant1907 variant1909 variant
General
Built1905-19071907-19101909-1913
ManufacturerBMAG, Grafenstaden
Axle config0-10-0T (Ten-coupled) 
Gauge4 ft 8 1/2 in (Standard gauge)
Dimensions and Weights
Length41 ft 0 1/8 in
Wheelbase19 ft 0 3/8 in
Rigid wheelbase9 ft 6 3/16 in
Empty weight129,962 lbs130,073 lbs133,380 lbs
Service weight162,921 lbs163,142 lbs166,669 lbs
Adhesive weight162,921 lbs163,142 lbs166,669 lbs
Axle load32,628 lbs33,510 lbs
Water capacity1,849 us gal
Fuel capacity5,512 lbs (coal)
Boiler
Grate area24.2 sq ft
Firebox area124.1 sq ft123.7 sq ft123.8 sq ft
Tube heating area1,292.9 sq ft1,328.6 sq ft1,344.3 sq ft
Evaporative heating area1,417 sq ft1,452.3 sq ft1,468.1 sq ft
Superheater area341.2 sq ft461.9 sq ft444.5 sq ft
Total heating area1,758.2 sq ft1,914.1 sq ft1,912.6 sq ft
Variant1905 variant1907 variant1909 variant
Power Plant
Driver diameter53.2 in
Boiler pressure174 psi
Expansion typesimple
Cylinderstwo, 24 x 26 in
Power
Power sourcesteam
Indicated power1,055 hp (787 kW)
Optimal speed16 mph
Top speed25 mph
Starting effort41,703 lbf
Calculated Values
steam locomotive
freight
tank locomotive
last changed: 01/2022
loading...

We use cookies to save the following settings:

  • selected navigation structure
  • selected language
  • preferred units
  • spelling of railway company names

If you refuse the use of cookies, the settings will only be retained for the current session and will be reset to the default values the next time you visit the site.

Display of units

Here you can set the desired unit system for the technical data.

  • Metric: Lengths in meters, weights in tonnes, and volumes in cubic meters
  • Imperial (UK): Lengths in feet/inches, weights in long tons and volumes in imperial gallons
  • Imperial (US): Lengths in feet/inches, weights in pounds, and volumes in US gallons
  • Individual: Depends on the country of origin of each locomotive
Operator names

Here you can set the display of railway company names.

  • Short: Abbreviation or short form of the name
  • Standard: commonly used name, partially translated to English
  • Complete: full name in local language