loco-info.com
The reference for locomotives and railcars
Navigation
Random
Search
Compare
Settings

Navigation

Page views since 2023-01-26: 690361
Imperial-Royal State Railways class 310
Czechoslovak State Railways class 375.0 and Polish State Railways Pn12
Austria-Hungary | 1911
90 produced
310.23 in April 2008 in the Heizhaus Strasshof
310.23 in April 2008 in the Heizhaus Strasshof
Theslu

With the class 210 express locomotives completed in 1908, Karl Gölsdorf had already shown that the lower coal quality in Austria could be successfully exploited by reversing the 4-6-2 wheel arrangement known as the Pacific and thus achieving a larger grate area. While the class 210 only had a steam dryer, the class 310 was developed with a superheated boiler and an otherwise almost identical design.

The cylinders had the same dimensions as the 210 and still acted on the second driving axle. However, the valve bodies were no longer cast in one piece so that the entire part no longer had to be replaced in the event of defects. Although the boiler dimensions of the 210 and 310 were roughly the same and the steam dryer of the 210 was larger at 69.9 square meters than the Schmidt superheater of the 310, the latter was significantly more efficient.

Howden's Locomotives of the World

Between 1911 and 1916 a total of 90 examples were made by various manufacturers. Depending on the series, the boiler pressure was 15 or 16 bars. The permitted maximum speed remained at 100 km/h, but could be exceeded without hesitation in order to make up for delays. After the First World War, a total of 35 came to the CSD as class 375.0 and twelve as Pn12 to the PKP. During the Second World War, the Reichsbahn included the 310 in the class 16 and later the ÖBB took over this number. They were only used until 1950 by CSD and until 1957 by ÖBB.

During the First World War, more locomotives were to be purchased, but the large firebox could no longer be manufactured due to a lack of copper. The solution was a brotan boiler with a smaller steel firebox. The result were the ten locomotives of the class 310.3, which with an axle load of 15.4 tonnes were no longer allowed to run anywhere in Austria. Seven locomotives that hadn't yet been delivered to the kkStB at the end of the war had to be sold to the Prussian State Railways due to the dissolution of the kkStB, which used them as the S 11 between Berlin and Katowice. The other three locomotives that had not yet been delivered were sold to the PKP and used as Pn12. After Upper Silesia was ceded to Poland, the first seven also came to the PKP, but during the Second World War they returned to Austria three under the leadership of the Reichsbahn together with the remaining three.

The 310 was Gölsdorf's masterpiece and is considered the best-known Austrian steam locomotive, which is not overshadowed by the later, more powerful 214. In fact, it was rather unpopular with the staff because the valve gear was hard to operate and the engine was very complex to maintain. For this reason, even in the period between the world wars, simpler locomotives were sometimes used and the 310 was parked more and more frequently. Today the 310.15 still exists in the National Technical Museum in Prague and the operational 310.23 in the Strasshof Railway Museum.

Variant310.0310.3
General
Built1911-19161918
ManufacturerFloridsdorf, Wiener Neustadt, BMMF, StEG, Breitfeld & DaněkFloridsdorf
Axle config2-6-4 (Adriatic) 
Gauge4 ft 8 1/2 in (Standard gauge)
Dimensions and Weights
Length70 ft 2 11/16 in
Length loco42 ft 7 7/8 in
Wheelbase34 ft 3 7/16 in
Rigid wheelbase14 ft 6 13/16 in
Total wheelbase59 ft 10 9/16 in
Empty weight174,606 lbs
Service weight189,597 lbs
Adhesive weight97,224 lbs
Total weight305,560 lbs
Axle load32,408 lbs
Water capacity5,548 us gal
Fuel capacity14,991 lbs (coal)
Boiler
Grate area49.7 sq ft
Firebox area162.5 sq ft
Tube heating area2,129.1 sq ft
Evaporative heating area2,291.6 sq ft
Superheater area467.2 sq ft
Total heating area2,758.8 sq ft
Variant310.0310.3
Power Plant
Driver diameter84.3 in
Boiler pressure218 psi232 psi
Expansion typecompound
Cylindersfour, HP: 15 3/8 x 28 3/8 in
and LP: 26 x 28 3/8 in
Power
Power sourcesteam
Estimated power1,743 hp (1,300 kW)1,877 hp (1,400 kW)
Optimal speed51 mph52 mph
Top speed62 mph
Starting effort21,747 lbf23,196 lbf
with start valve26,096 lbf27,835 lbf
Calculated Values
steam locomotive
express
Von Borries compound
Karl Gölsdorf
last changed: 06/2022
loading...

We use cookies to save the following settings:

  • selected navigation structure
  • selected language
  • preferred units
  • spelling of railway company names

If you refuse the use of cookies, the settings will only be retained for the current session and will be reset to the default values the next time you visit the site.

Display of units

Here you can set the desired unit system for the technical data.

  • Metric: Lengths in meters, weights in tonnes, and volumes in cubic meters
  • Imperial (UK): Lengths in feet/inches, weights in long tons and volumes in imperial gallons
  • Imperial (US): Lengths in feet/inches, weights in pounds, and volumes in US gallons
  • Individual: Depends on the country of origin of each locomotive
Operator names

Here you can set the display of railway company names.

  • Short: Abbreviation or short form of the name
  • Standard: commonly used name, partially translated to English
  • Complete: full name in local language